🏎️ Autonomous Robot Car
Design a self-driving rover with ultrasonic obstacle avoidance and PID line-following.
Overview
Combining multiple sensors to create an autonomous vehicle is a complex challenge. We will use an HC-SR04 ultrasonic sensor to detect obstacles, and an array of IR sensors to follow a line.
What you'll learn: Motor driver (L298N) operation, PID control algorithms for smooth line following, and finite state machines to switch between roaming and line-following modes.
Estimated time: 4-6 hours. Difficulty: ⭐⭐⭐⭐⭐ Expert.
Components Needed
| Component | Specification | Qty | Notes |
|---|---|---|---|
| Arduino Nano | ATmega328P | 1 | Compact footprint |
| L298N Motor Driver | Dual H-Bridge | 1 | Drives 2 DC motors |
| DC Motors & Wheels | 6V-9V | 2 | With gearboxes |
| HC-SR04 Sensor | Ultrasonic | 1 | For obstacle avoidance |
| TCRT5000 IR Array | 5-channel | 1 | For PID line following |
| LiPo Battery | 2S 7.4V | 1 | USE CAUTION WITH LIPO |
Step-by-Step Tutorial
1
Chassis Assembly
Mount the motors, L298N, and Arduino Nano to the robot chassis. Ensure the caster wheel allows smooth turning.
2
Wire the L298N
Connect ENA, IN1, IN2 to Arduino pins 9, 8, 7 (Left Motor) and ENB, IN3, IN4 to pins 10, 5, 4 (Right Motor).
3
PID Tuning
The hardest part of line following is tuning the PID constants (Kp, Ki, Kd). Start with Ki and Kd at 0, increase Kp until the robot oscillates, then dial it back and increase Kd to dampen the oscillation.
4
Obstacle Logic
Implement a state machine. If the ultrasonic sensor reads < 15cm, the robot enters the "Avoidance" state: reverse, turn, and scan for a clear path.
PID tuning requires patience. Make sure your motors are powered by a robust battery (like a 2S LiPo); a 9V alkaline battery cannot supply enough current.
Code / Configuration
autonomous_rover.ino
INO
// Autonomous Robot Car (PID Line Follower snippet) - Volt X
int P, D, I, previousError, PIDvalue, error;
int lsp, rsp;
int lfspeed = 150;
float Kp = 0.05;
float Kd = 0.5;
float Ki = 0.0001;
void setup() {
// Initialize motor pins and IR array
}
void loop() {
// Read 5 IR sensors to determine error (e.g. -2 to 2)
error = getLineError();
P = error;
I = I + error;
D = error - previousError;
PIDvalue = (Kp * P) + (Ki * I) + (Kd * D);
previousError = error;
lsp = lfspeed - PIDvalue;Reviews & Ratings
—0 reviews
Sign in to leave a review
Loading reviews...